Tractor Talk Discussion Board |
Re: Skidloader mounting plate on tractor loader?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PaMike on October 06, 2005 at 09:20:00 from (24.152.213.144):
In Reply to: Skidloader mounting plate on tractor loader? posted by K.B.-826 on October 05, 2005 at 20:27:39:
I did just what you are talking about on my 1755 Oliver(85hp). Call around to equipment dealers and any salvage yard and buy the entire setup off a skidloader. I got mine for $75 from the IH dealer. $75 dollars is a steal. It was a used take off that was too worn for a contractor. Once the latches wear some they will pop open then they use the hydraulic jackhammer. I dont use a jackhammer so it works great. Once I got the piece is was just a matter of fabricating it up to my wider loader arms. It took some work, but I did it. You can buy the skidloader plate new, but they are around $800.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|