Tractor Talk Discussion Board |
Re: Cast iron...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Duner Wi on September 22, 2005 at 18:36:58 from (63.50.8.139):
In Reply to: Cast iron... posted by Stan(PA) on September 22, 2005 at 08:43:08:
I have been using a self etching primer from BASF # Zip 834 for many years and like it lots. I keep some in one gun and when I get something clean I spray a couple of thin coats. As long as I keep it indoors and dry I can let it set for years with out rust coming back , When time to paint I give it another coat and then paint shortly after. Epoxy primer might do the same for you but I don"t like mixing small quanities of primer with a limited shelf life after mixing. I have put epoxy (Nason) over Zip 834 but it was only 3-4 years ago so don"t really know how it is for the long term. I would expect it to last tho. I would not put rust converter on anything I had a lot of labor in. I have used it when in a bind and it did work for for a few years. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|