Tractor Talk Discussion Board |
Re: Paging Old Fashioned Farmer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old fashioned farmer on September 10, 2005 at 06:25:19 from (70.104.108.38):
In Reply to: Paging Old Fashioned Farmer posted by Brian in Ohio on September 09, 2005 at 17:09:59:
howdy brian, Much as I hate to say it, I can"t make it up there this weekend. Busy on Sunday and have folks comin over with their tobacco Saturday. They"ve run out of barn space and we aren"t raising the stuff anymore so I volunteered our barn. Get to have a little show though since I have to pull the old van brunt drill and huber thresher out so they can run the wagon through. Fun fun. God bless ya buddy. p.s. tuffy didn"t buy my R without me knowin did he? ha ha --old fashioned farmer
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|