Tractor Talk Discussion Board |
Re: Old iron on the job everday!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dr.sportster on September 07, 2005 at 12:56:52 from (209.247.222.98):
In Reply to: Old iron on the job everday! posted by ShepFL on September 06, 2005 at 23:51:39:
I was on the piece of junk thing once all run by high school guys.A kid was giving a talk on the way up.Hot cinders were coming in the window loud clunking noise from the cog gear.The kid said "any questions" I said" yes how many people have been killed on this thing".Everybody in the passenger car turns around and gives me a dirty look.Then the kid says" twelve people have been killed if you lose the piston you go down the mountain backwards real fast".It sure beat hiking up anyway.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|