|
Tractor Talk Discussion Board |
Oil Pressure Gauge Glitch !!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on August 16, 2005 at 17:25:48 from (64.42.242.46):
Got a little concern here so here's the story. I have an early 60's MF swather engine (flathead Continental 4 cylinder) that I dropped into my 1941 Case V (with the same engine but 20 years older and a bit smaller, 124 vs 140 cubic inches). The newer engine bolts right into the Case V no problem. I hooked up my Case oil pressure gauge today and it is a low-range gauge which only goes to 30 pounds. That was OK before BUT the new engine pins the needle on the 30 pound mark. Obviously the newer engine is putting out more than 30 pounds of pressure. Easy solution is to put in a higher range gauge but mine is a Case gauge and I don't want to give it up. Question is, will the extra pressure mess up the gauge or will it be OK? I don't mind it showing 30 pounds all the time as long as the gauge can take it. I don't want one of the "new" gauges, they just don't look right. By the way, this gauge is accurate, I tested it on the last engine it was mounted on and it ran at about 18 pounds of oil pressure.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
