Tractor Talk Discussion Board |
Re: 220 wire size Hello buickanddeere and T-Bone
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 30, 2005 at 06:58:42 from (216.183.146.189):
In Reply to: Re: 220 wire size Hello buickanddeere and T-Bone posted by john in la on July 29, 2005 at 22:31:13:
If the breakers have large enough lugs. You can just daisy chain across from the top of one breaker to the next. Best bet would be to bring 80 amp #4 power to the disconnect beside the AC compressor. From the bottom of the disconnect into the 40 amp for the compressor. And also from the bottom of the disconnect to the inside 60Amp then daisy chain over to the 30amp. Good point there earlier about having to use flexable conduit into the compressor. I forgot to mention that. THHN wire is good stuff too. The #4 to the compressor 1st will assist starting when voltage is a bit low during utility brown-outs. Or if your service is loaded heavy with other loads. I do like to pound a 10' ground rod in for things like outside pool pumps, AC units etc.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|