Tractor Talk Discussion Board |
shortening PTO shaft with zerk fittings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB OH on July 29, 2005 at 08:53:29 from (206.183.9.18):
I have a '63 Ford 2000 to which I just added an over running clutch, but the PTO shaft is now too long for my bushhog. My understanding is that I have to shorten the PTO shaft to accommodate the ORC (by about 4" or so?). Here's my dilemma: The PTO shaft has a grease (zerk) fitting approximately 2" from the open female end of the shaft, with another zerk another 4" down from the first. Cutting the shaft at 4" from the end will sacrifice at least the first zerk, and leave the second one about 2" from the end. There may be some sort of seal or something as well, because the shaft has a "pinch" or 1/8" thinning of the diameter surrounding the pair of zerks. I don't know if this is typical, or if there is some other purpose I'm unaware of, other than greasing the extending shaft. Should I just cut the shaft and leave the one zerk remaining, or is the "pinch" surrounding the two zerks doing something I should be concerned about?
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|