Tractor Talk Discussion Board |
driver, bad hay baler stories
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 25, 2005 at 01:12:35 from (216.183.134.92):
In Reply to: bad hay baler stories posted by havvey on July 23, 2005 at 16:29:01:
I was stacking bales on the wagon behind the JD 346.The tractor happened to be the 60 row crop, one of the restored JD two cylinders getting a workout. At about 9/10 loaded the driver got too close to an overhanging tree limb and tried to make a panic stop. The more he panicked the harder he pushed that left wheel brake. The right hand was frozen in terror to the steel wheel instead of pulling the clutch. The driver had grown up on orange tractors……................... The 60 was lugging down, putting hard and loud with the heavy load, climbing a hill and still running the baler. The PTO shaft was chattering as the driver "circled the wagons" in pioneer wagon style while under attack. As a bale dropped off the chute and dragged under the wagon . The waving and verbal “instructions” from the wagon didn't help much either.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|