Tractor Talk Discussion Board |
Re: O/T force feeding calves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DRL on July 19, 2005 at 14:52:36 from (24.32.122.56):
In Reply to: O/T force feeding calves posted by Tim...Ok on July 19, 2005 at 10:54:59:
Tim, If they are still alive, would call a vet in ASAP since you haven't had much experience with baby calves. Think baby calves are about the hardest thing to keep alive if separated from mom. When I still lived at home, we usually had 15-20 bucket calves. Was a never ending cycle of shots, scour pills, pink eye meds, etc... You had to be on your toes in order to spot anything that might be going wrong. One day they are fine, the next scours or a cough, dead the next. If you didn't spot a problem eary, you were usually too late. Think I would rather have milked 15-20 head rather than this.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|