Tractor Talk Discussion Board |
Re: HELP - 48 AC WD TUNE UP INFO NEEDED
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glen in TX on July 15, 2005 at 13:08:15 from (65.249.225.40):
In Reply to: HELP - 48 AC WD TUNE UP INFO NEEDED posted by CLAY RANDALL on July 15, 2005 at 08:08:31:
Some tune up specs in left hand columns here and they have some manuals on here too. Do a search on the AC forum for lots of info too or just ask there. If you have the FM-X mag there should be a mark on the magnet shaft gear that aligns with the "C" mark on the fibre rotor gear. Then get your engine on TDC on #1 front cylinder and line up the rotor with the tab in the cap at about 11 o'clock to time the mag to engine. Set points on the X mag to .015". On the FM-J mag align the mag gears the same way... C to the gear mark for Clockwise drive mags and A to the mark for Anti-Clockwise mags and set points at .020". There was some good AC info at this also: http://dueyschutter.freeservers.com/photo6.html If you need more help let me know.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|