Tractor Talk Discussion Board |
Re: air in hydraulics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cheinzle on July 11, 2005 at 15:12:38 from (207.5.113.115):
In Reply to: Re: air in hydraulics posted by cheinzle on July 06, 2005 at 11:55:51:
okay, i completely bypassed the filter for testing. it is now: res->pump->spool->cyl->spool->res the cylinder seems to stroke fine both directions without delay until it is loaded in the extended direction. When the spool is moved to the retract position, the load drops quickly and suddenly. When the cylinder is retracted enough to fully unload it, it pauses just after the load is removed, then resumes, as though the load pushes the rod in until there is no more load, then it has to wait until the air in the cylider is compressed enough to continue retracting. Im no professional at hydraulcs, yet no newbie either. Ive built 2 other loader systems from scratch in the past. I had air getting into the system on one previous system when the returning oil stirred up the resivoir enough to make air bubbles, but that was quickly solved. This one is baffling me. Im considering perhaps a seal on the cylinder itself.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|