Tractor Talk Discussion Board |
Valve seats on a Detroit 53 series
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kirk_t on July 05, 2005 at 12:17:17 from (70.18.153.111):
Hello All. I'm working on a 453 Detroit Diesel with 4 valve heads. The engine drank water for better than 10 years so the head needs major work. (BTW, The block is being swapped.) I've cleaned out the exhaust ports and did a mild porting job on them to smooth out the rust pits and casting imperfections. I'm also going to replace the valves and seats. What is the best way to remove the seats from the block? I was considering MIG welding a bead around each seat to shrink them. Is there a better way? Is there a good way to install the seats without the proper DD tool? I've heard about heating the block and freezing the seats but I'd prefer confirmation before I screw up the head. After the seats are installed will I need to have them ground to spec or will hand lapping be sufficient? Thank for any info. Kirk
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|