Tractor Talk Discussion Board |
Re: Removing tractor tire...Help!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MSM on May 21, 2005 at 12:11:11 from (4.155.24.32):
In Reply to: Re: Removing tractor tire...Help! posted by Dug on May 21, 2005 at 11:42:16:
Run the 2 jack bolts in as tight as you can,smack the end of the axle squarely with a big sledge,tighten jack bolts again,hit end of axle again,repeat as necessary until the cone comes loose. The bolt going in side ways is the rack bolt to adjust the wheel in and out.You will probably find it is frozen.To get the wheel off,(if the adjuster is frozen)once the first locking cone is loose,is remove the bolts for the inner cone,remove it,spin the wheel a half turn on the axle and slide the wheel off. Once it is off,you can clean, free up and lube the adjusting mechanism.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|