Tractor Talk Discussion Board |
Old Horse Tank
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dachshund on June 22, 2007 at 04:57:25 from (139.55.238.165):
I had been wanting the old horse tank that was sitting on a farm near here. It was made from native rocks and covered in concrete. Yesterday, we went over in the morning to see how hard it would be to move it, then came back in the afternoon to try. We found out that it was one HEAVY monster! So heavy, that a MM U302 could only lift a corner about 8". We ended up breaking it loose from the ground, sliding the trailer underneath one corner, then pulling it on the trailer with the tractor. The bottom of the tank was made from rocks "fist size to head size", bonded with concrete. We knocked a few rocks off the bottom, but all is well. Unloading was easier. It is amazing that this tank has suvived time and the weather for 94 years since my Great-Grandfather built it in October of 1913. I still have to get a spot prepared for it, but it is here anyhow!
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|