Tractor Talk Discussion Board |
Re: Molyslip Mr. Moly
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by James2 on May 11, 2005 at 12:16:56 from (12.2.142.7):
In Reply to: Molyslip Mr. Moly posted by RandyR on May 10, 2005 at 01:39:44:
I read a lot of technical information about moly before it was available and thought it would be good to try. Later when it did became available, I used it and thought it worked OK, but really didn't get any fuel or power improvements to back it up. Others who were using it at the time said both power and fuel consumption improved. They stopped using it because it was building up in the oil pan and lumps were coming out during oil changes. I used it at one third up to one half recommended rate and only every other oil change. According to the tech articles, moly will coat the moving parts and has staying power, therefore really one doesn't need to overkill adding it. I haven't seen it available locally for quite a few years. Yes I would use it again, but in the manner I used it before. Overall I think the main benefit is preventing cold start wear, and a little will do a lot of good.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|