Tractor Talk Discussion Board |
Re: Grass cutting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by phil(va) on April 25, 2005 at 04:55:40 from (63.188.16.244):
In Reply to: Grass cutting posted by Middopman on April 25, 2005 at 03:33:59:
If you like old machinery, you might want to consider one of the older tractors with a wide front end, which will give you stability and not hurt your pocketbook too much. Consider a Ford NAA or Ferguson TO-35 or some such. Those are excellent old tractors and parts are readily available. They have 'category one' three point hitches and thus can use three point hitch equipment and can handle mowers up to six feet if the grass isn't too high, or five feet in most any grass. Also, if you decide to get a plow or disc, etc., for gardening you will be all set. There are a number of good mowers, the Caroni being one that is not so expensive as some of the others and does a good job. You can also put a bush hog behind these tractors, and some bush hogs sit low enough and cut clean enough that they can almost do the job of a mower in a large field such as yours.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|