Tractor Talk Discussion Board |
Re: Magneto problems ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on March 13, 2005 at 12:51:55 from (66.163.134.177):
In Reply to: Magneto problems ? posted by tractorfrank on March 13, 2005 at 11:58:38:
Does the mag have an impulse? If it does not, (or it HAS an impulse that's not working), the low RPM's of the mag at cranking, compared to running it with the drill is making the weak spark problem show up. I have an OLD 1.5 KVA Kohler 4-cyl genset that has no impulse on the mag. The genset is electric start, by 2-12 Volt batteries in series for 24 Volts. It cranks quite fast with the batteries, and starts well. However, if you try to hand-crank it, you've got to crank like HECK to get enough speed to get a good spark out of the mag. Poor points or/or condensor, weak coil, or magnets in need of recharging will make the mag's spark even weaker at low RPM's.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|