|
Tractor Talk Discussion Board |
Jon H...Chev 350 oil pres
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on February 25, 2005 at 06:21:58 from (209.151.116.198):
Jon, Your comments: "With only a few exceptions,Chevy not being one of them,10 psi per 1000 rpm is enough for a heavy duty truck or even a race engine. 10 at idle and 30 at 3000 is plenty. A high pressure or high volume pump on a chevy just causes faster distributor gear wear.
.............." Respectfully asking: Would you mind sharing with us the origin of your comment concerning 10/1000 and the reason why I should believe you? If you are a reliable source of information I will be very grateful. I have worried for years about low oil pressure, especially in the GM 350. I have a Ford and Dodge and the pressure locks right in in the 50ish psi range regardless of idle or 2500 rpm, regardless of hot or cold. !@#$%^&*()_ Chev is all over the place. Been told they use a high volume, low pressure pump and don't do as others do which is to have a high press, low volume pump and a press relief valve which is what the other 2 must use or they couldn't maintain a steady pressure under all those variables. Well I know the physical relationship pv=kt and I don't buy the Chevy logic; not yet anyway. Course I haven't done any research on engine lubrication system types to understand why there are the differences mentioned. Guess if I was all that curious I'd have done that. Maybe I will if still concerned after your reply. Have a Perkins diesel which looses pressure when at operational temp and at idle it goes to around 15 psig at about 800 rpm idle. Don't want to overhaul it as it runs good and the Perk has lots of parts to fool with, but would like to stop worrying about pressure drop off at idle. My other tractors hold at least 30 at idle. (Use the same type 15w-40 or 50 in all engines) Thanks, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
