Tractor Talk Discussion Board |
Re: 350 chevy motor help
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1945 A on February 11, 2005 at 07:21:34 from (199.245.220.253):
In Reply to: 350 chevy motor help posted by 37 chief on February 10, 2005 at 12:09:42:
Chief--- I"ve built several 350 engines over the years, and have never welded the pick up tube to the pump----that"s enough interference fit, that it"s just not going to come out in normal use, if ever. I always start by putting the tube partially into the pump---far enough that it will stay put, but not all the way, then, set the oil pan in place, and push the pan against the block---that will give you the proper angle for the pick up tube, remove the pan, and then drive the tube the rest of the way into the pump housing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|