|
Tractor Talk Discussion Board |
Re: Felix Snowplow Help
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by felix on January 24, 2005 at 19:29:05 from (205.188.117.7):
In Reply to: Felix Snowplow Help posted by Brad S on January 24, 2005 at 15:33:34:
brad mine is made using mostly scrap metal hanging around and part of the original frame. but it looks nice and is real strong. i have a picture taken a couple years ago showing the front of it with my dad plowing. if you want e-mail me with your address so i can send the pic i don't know how to put pictures on this site. i'm not good with metal types but we used 2 pieces of metal if you look at the front they look like [ a c- shaped metal bolted them along the frame rails on the side of the tractor. took the original plow frame ours was from a 72 scout my dad sold along time ago and welded it on top. for a piston we use the one we used for implements i run the 2 hoses (14 ft long) to the back and use the hydraulic remotes to lift. than off the frame in the front we ran 2 thick pieces of angle iron down to where we made the holes for the plow to mount made a bracket behind that so we could bolt another piece of metal at an angle under the axle and up to the frame near the engine area where we made it bolt on. that way you can remove the bolted piece and unbolt the frame and slide the whole thing off the tractor. it hard to describe the pic will do it justice but it looks nice and does the job. only cost i had was the hoses some bolts and a couple welding rods
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
