Tractor Talk Discussion Board |
Re: Ideas for new shop building
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J.Schwiebert on January 10, 2005 at 09:41:06 from (216.201.29.60):
In Reply to: Re: Ideas for new shop building posted by will in Tx./Mn./ USA on January 09, 2005 at 21:05:08:
About one foot from each end of the I-beam and then one in the middle we placed 4 inch PVC pipe next to the I beam. The PVC pipe extends below the floor and below the I-beam. It is a closed loop (like the letter U and we have a 3/8 log chain in each one. We can either hook another chain or chains to these or use a Clevis(s) to hook other attachments to this. I f you want a picture I will send one to you later this week. I got the idea from a friend of mine who did that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|