Tractor Talk Discussion Board |
Re: Prony/pony brakes
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JT on December 09, 2004 at 06:23:08 from (69.220.199.69):
In Reply to: Re: Prony/pony brakes posted by Joe Evans on December 08, 2004 at 20:28:46:
Joe, I appreciate all the input you have givin me on this. I never did really understand how they work and such, but, they were alwasy kinda neat to watch them belt an old tractor to them and them listen to her belller. I have quite a few engines from Briggs 1.5hp to McCormick Deering LB 3-5. so a big pully on one end and a small one on other end would be a nice way to go. Now,for another question, how do you have the shaft supported, is it in a steel clamp with grease cups or is it running in pillow block bearing? Jim
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|