Tractor Talk Discussion Board |
Motorcraft vs Delco
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom S. in Tn. on December 06, 2004 at 06:34:06 from (65.7.69.158):
In Reply to: Re: Change external reg'd alternator to internal posted by Jon H on December 05, 2004 at 20:39:24:
I"m working on a big 90 something amp unit [called a "blue back"] on an 8000 series truck, and the new replacement appears to have a solid state reg inside the rear frame housing. I have a big 130 amd Leece Neeville unit off a bus, but I wanted to stay with an updated Motorcraft. Like Delco or etc., they all require 12v switched current with a diode or bulb to prevent current backflow, and the 12v output connected in line with the battery. I have the principle, but I did not know what was what on the back of the 2 alternators and where the switched 12 volts should go. I have to check with a meter at the regulator plug to find the switched 12v [stator or field?] and take that wire from the fender and out of the harness and over to the alternator [supply you say?]....I think. I have replaced old ext. reg"d generators with int. reg"d alternators, and I "think" the process is about the same. Isn"t it? Thanx; Tom S.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|