Tractor Talk Discussion Board |
Re: JD-60 hydralicpump drive
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike M on November 21, 2004 at 06:33:08 from (65.238.9.144):
In Reply to: JD-60 hydralicpump drive posted by orest sask. on November 21, 2004 at 05:41:56:
Let me attempt to answer again as on my first one I lost my connection. What type of hydraulic equipment are you running ? On the AR tractors built before the 60 they used a roller bearing in there instead of a bushing.I would think this was better but I don't know why they switched. I fixed a 620 that had this problem from running on a feed grinder which has hydraulic motors on the augers.This puts a constant load on the pump and idler gear which these tractors were not designed for back then. I drilled and tapped the governor case and teed into the oil line going up to the gauge and feed oil pressure into the center of the shaft and plugged the little oil hole where the oil drips into around the pin that locks the shaft from turning with silicone sealer. I'm going to try to post before it's lost again. If you need more details we'll try again.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|