Tractor Talk Discussion Board |
Is he a friend ??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Punchie on November 19, 2004 at 06:43:53 from (4.124.67.167):
In Reply to: How much should I pay this feller? posted by Brian in NY on November 18, 2004 at 06:42:00:
Hi Brian Bin some time out of the fab. market places. But the guys welding in the market place around here in a shop lucky to see 15/Hr just too many from the steel mills in western PA. If he is using his own equipment look to pay 25/30 an hour for one day worth of work, if lite welding like a small mig. and close 25-30 would be fair, for two hours. Prep is the timly thing not just welding, may take hour to make something right and mins to weld it. If one of may friends call me up said hey, get over and weld this. I would say when!! But would look for a nice lunch, dinner, if I was cold or hot something to drink. Nothing worse than whatching a friends wife set in the nice warm house and your outside, in the weather!! No drinks and or even ask if you were in need of anything. If he is a friend make him feel like one, he not looking to get rich off of you, for helping you out that why he not willing to charge you big bucks. Have A Good With your friends Good One Are Hard to Come By , Help each Other out if you Can Teddy
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|