Tractor Talk Discussion Board |
Re: Any instrust in something like this? Picture
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve in IN on November 15, 2004 at 11:58:50 from (68.254.88.254):
In Reply to: Re: Any instrust in something like this? Picture posted by Willy-N on November 15, 2004 at 06:59:24:
I bought one similar off E-bay for about $60. Since mine is on a cat 0 3 point, I don"t worry to much about it rising up. I do move around a 1600 lb empty trailer with it, at low speed. I have seen the adapters with the chain. One has the chain welded into the bottom of the upright. It then slips into the upright tube when not attached to the drawbar. Pretty slick. Mine is made for a Cat 1, it would be nice if it was a little bit smaller. I just changed out the pins and do fine with it. I have another A frame adapter for the forks and for sleeve hitch attachments. The forks will lift at least 500 pounds. Its on a JD 318. In short, I believe you already have a market...
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|