Tractor Talk Discussion Board |
Re: Brake controller question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by VaTom on October 26, 2004 at 18:57:08 from (64.4.123.9):
In Reply to: Re: Brake controller question posted by rustyfarmall on October 26, 2004 at 17:02:24:
Hi Rustyfarmall, That brings up a question I've had. Like Kelvin, I couldn't get another hydraulic controller. Unlike Kelvin, I much preferred my hydraulic one over the Prodigy I'm now using. The only reason I switched was a new-to-me trailer with 8 brakes. The hydraulic controller couldn't handle that many brakes. The Prodigy's working, but I find it more difficult to keep adjusted than the hydraulic one. And the installation angle required to work wasn't what the instructions said. A buddy was delighted I was retiring my hydraulic unit. Like me, he prefers them. Why do you think the electric controllers are "a vast improvement"? Other than avoiding the plumbing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|