Tractor Talk Discussion Board |
Backhoe Hydraulic Cooler Removal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AndrewS on October 12, 2004 at 06:56:51 from (65.88.43.2):
I need some help trying to remove the hydraulic cooler on my backhoe. I can't get the hydraulic lines off the cooler and don't want to break anything. There seems to be two nuts on each hydraulic line where it enters the cooler. The one closer to the cooler is a narrow nut where the one farther away is much wider. Both use a 1 1/4" wrench. Should I try to hold the narrow nut while turning the wider nut or should both nuts turn at the same time? I tried turning the wider nut while holding the narrow one and it would not budge. I tried turning the wider nut but the narrow nut turned with it and it looked like the hydraulic pipe was going to bend so I stopped. At this point I could really use some advice. The machine is a Dynahoe 160 and the hydraulic cooler weeps quite a bit of hydraulic fluid.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|