Tractor Talk Discussion Board |
Re: John Deere 40..420 crawler final drives
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by johndeeregene on September 15, 2004 at 19:50:50 from (205.188.117.10):
In Reply to: John Deere 40..420 crawler final drives posted by michael solan on September 15, 2004 at 05:17:28:
the 40 final drives will fit a 420 just fine, but i would use them. the 40 final drive castings were pretty weak. so most of them cracked or broke. the 420 casting were made stronger by casting in a couple of brases in them. they look like a couple of splines goin out from the center. if you have a good 40 casting them i would sell it since the people doin 40"s are always lookin for them an buy a couple of 420 casting. i just did a 40 crawler an i found good castings in california. they were not cheap an they were just as costly to ship back to ia. just my 2 cents worth johndeeregene
Follow Ups:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|