Tractor Talk Discussion Board |
Re: galvanized metal against PT lumber
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on September 05, 2004 at 05:59:56 from (209.151.112.94):
In Reply to: galvanized metal against PT lumber posted by BSer on September 05, 2004 at 04:52:47:
Another thought with the felt paper, is that it, being a vapor barrier, it may reduce the possibility of metal sweat (condensation) problems that are associated with metal buildings/sheeting. The Metal building folks, and Home Depot, sell a screw with a rubber seal on the head. For wood purlins, it is pointed (no metal puncturing drill bit on the end) and drives with a 1/4 " bit. Some of these are painted, some galvanized, and they are made of high tensile strength material which would resist a chemical attack, much better than soft steel that hammer driven fastners are made from. Good luck and hope you the best. Hope those "girls" lined up across the Atlantic to E. Coast of Africa leave you alone. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|