Tractor Talk Discussion Board |
Bamlett Mower T-M-1 Info...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Barry1980 on September 04, 2004 at 09:09:28 from (217.137.188.11):
My neighbour and I are currently restoring a Bamlett T-M-1 Mower. I don't know how old it is, although I think it was late 40s early 50s. It's a self lifting mower with the cutter deck on the right hand side if you look at the trailer from behind. It's tractor pulled. Basically I'm trying to find some information out about that sort of mower. We're not stuck exactly, but it would be interesting to see a picture of an original or restored one to see if we've got it all right (as it was little more than a pile of bits when we started). Last night I spent over 6 hours scouring the internet for information about the machine but all I could find was information about the early 1800's horse drawn versions. Can anyone point me in the right direction of a book? or a website? or a magazine? or has anyone taken a photo of one at a rally or knows the whereabouts of a photo of one? I can take some photo's of the mower later if that helps anyone understand what I'm drivelling on about. Regards, Barry
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|