Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: Newbie about to purchase first tractor


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by txblu on September 02, 2004 at 05:57:00 from (199.46.199.231):

In Reply to: Re: Newbie about to purchase first tractor posted by Indydirtfarmer on September 02, 2004 at 04:03:36:

Not familiar with that tractor. Don't know if it's 30 or 300 hp which would surely make a difference.

Agree with the handiness of the loader. Sometimes they get in the way, but once you have one you won't be without (been there done that). I think the $1000 is a little soft. New they are around $4k, again depending on size.

A fresh overhaul on a diesel from a reputable shop is a super plus. The fact that you confirmed the work with the workers is excellent. I was worried about the ether comment but you covered that with your info about the starting aid not being operational. Don't know where you are located so ether might be a necessity. Since some Original Equipment Mfgrs. (OEM) put ether dispensers on their tractors, it can't be all bad if used according to directions....engine cranking and a little squirt or two.

Seems that most all farm tires are weather cracked. I have some less than 2 yrs old that sit under a shed and are already starting to crack. If they are physically intact otherwise, that shouldn't be a problem.

So take off the loader at $1500 and the overhaul for $2k (1k parts, 1k labor) and $1000 worth of tires you don't have to buy and the guy is giving you the tractor with a $500 bill wrapped around it to boot. Sounds like a heck of a deal to me.

I usually have to pay $4k for the tractor (40 hp area), then overhaul it, then paint, fix little things broken, then new rubber, wind up out $6500 and no loader.

Good luck on your decision.

Mark




Follow Ups:




Post a Followup

:
: :

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy