Tractor Talk Discussion Board |
Re: john deere B cylinder wall
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TheRealRon on August 16, 2004 at 06:42:49 from (69.179.30.24):
In Reply to: john deere B cylinder wall posted by centenaryhills on August 15, 2004 at 13:47:03:
If I were planning on keeping the tractor I'd sleeve/bore it. But this is your call. If it's just one deep scratch the worst that might happen is that that plug may oil foul once in a while and there may be some small compression loss. Here's a trick I'll share with you. If you put it back in service as it is, add a can of "Restore". It really does work. It's not likley to heal a scratch that deep but it will fill it in some... maybe enough to solve the problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|