Tractor Talk Discussion Board |
Re: Baler questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on August 13, 2004 at 06:19:43 from (199.46.199.233):
In Reply to: Re: Baler questions. posted by paul on August 12, 2004 at 17:35:37:
My baler has 8 belts covering a 60" window. They are continuous and run on about 8 rollers scattered around the chamber. At the upper end of the throat is a roller that is square, like a paddle wheel. At the entrance to the chamber, the belts run opposite to oneanother in opposite directions. The only way the bale can start is to get squeezed between these opposite rotating belts. The paddle wheel helps this occur. Friction, as I've learned, between the belt and crop are essential. The springs keep tension on the belts as they expand with the chamber filling. The more spring pressure, the more dense the bale and of course the heavier. Go and ask someone who has what you want to buy and listen to what they have to say. Good luck, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|