Tractor Talk Discussion Board |
1070 hydraulics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by aaron on July 25, 2004 at 16:07:30 from (209.90.162.28):
I have a 75 1070.I am running the loader on the remote couplers.It worked fine all winter lifting round bales, feeding cows (a little slow but works).Now, the loader still goes up and down with little or no load, but it will not pick-up a bale.It starts to lift, then just stops and seems to lose pressure.Trans presure gauge rises a little and returns to normal, almost immediatly. Now for the wierder part: if I rev-up the tractor to try for more pressure and continue to try and lift a bale, after about 4 sec. the tractor loses all hyd. pressure ( no trans pressure,no power steering)and will not recover. Shut the tractor off for a few seconds,then restart and pressure returns in trans.,steering and couplers. Oil level in site glasses looks good when tractor is shut off but out of site when running(as it should be, I think). Have tried in-gear with clutch in and out of gear with no clutch, with no luck.Trans works fine in all gears. Any thoughts or ideas would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|