Tractor Talk Discussion Board |
Re: Re: Re: 8N won't start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by nebraska cowman on July 24, 2004 at 17:41:05 from (65.162.146.31):
In Reply to: Re: Re: 8N won't start posted by matt on July 24, 2004 at 17:02:27:
not hard at all.... Take out the #1 spark plug, (thats the one at the front of the motor) Turn the motor over slowly with the hand crank, (helps to have a friend) while holding your thumb or finger over the spark plug hole. When the piston comes up on compression stroke you will start to feel air pressure. then use a screwdriver or piece of wire or something to determine when the piston reaches it's highest point. That is "top dead center" that is when the points should be just starting to open and which ever hole in the distributer cap the roter is pointing to will be for that plug wire.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|