Tractor Talk Discussion Board |
Re: Re: Re: how to weld draw bar
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thurlow on July 16, 2004 at 18:58:23 from (65.255.98.21):
In Reply to: Re: Re: how to weld draw bar posted by Ray,IN on July 16, 2004 at 18:48:38:
I have fixed several (also built some from scratch) using either a rod of the correct diameter or a purchased implement pin (has threads, which are not used as such).Cut a "slot" out to a depth of about 3 inches in the drawbar.....weld the pin/rod in. It may not look completely original, but can be made to look good, depending on the effort you put into it.....
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|