|
Tractor Talk Discussion Board |
Re: Re: Re: Kim, could we please...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on June 24, 2004 at 16:49:45 from (68.188.227.110):
In Reply to: Re: Re: Kim, could we please... posted by tlak on June 24, 2004 at 08:47:19:
Tlak, As you well know, we have had some passionate disagreements politically, but I agree with you here. As I am sometimes one of the most passionate debators,, it doesnt detract from the fact that we here are all part of one big family. Not unlike sitting around the feed store, grain elevator, or fertilizer plant, talking about everything under the sun including politics and sometimes even farming and tractors. I will say that for as intense as some of the O.T. discussions have gotten, some of the people who object to them should try going to some of the political forums. Sadly they are nothing but four letter words and very little if any substance. Its hard to define what is appropriate and what is not, and I think Kim has done a magnificent job of providing a place, not unlike the feedstore or grain elevator, where we can talk about anything. including our health, our children ang grandchildren, our tractors, and yes, our politics. Being tractor enthusiasts doesnt in my opinion make us one demensional, in fact it only adds to our demension. I have no objection, however to an OT topic being removed after a couple days to condense space as they can get lengthy.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
