Tractor Talk Discussion Board |
Re: 1950 A pulley bearing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy V(SD) on June 09, 2004 at 23:20:45 from (64.33.241.38):
In Reply to: 1950 A pulley bearing posted by Larry T on June 09, 2004 at 11:08:33:
Larry, I grew up on two cylinder JD's and I've done a lot of clutches and I've never replaced that clutch bearing in my life nor have I ever had one go out. If you have the clutch apart put the tractor in neutral and rotate the pulley. if you feel any play up and down or any roughness then you may wan't to replace the bearing. Otherwise, leave it alone. If you are going to replace the clutch facings, there is also one behind the center on the crank. To get to it, remove the bolt on the end of the crank. Then take your drawbar out and place it over the end of the pulley. line up 2 holes in the drawbar with the two slotted holes in the center of the clutch. place two 1/2 inch bolts in the slots that are long enough to go through the holes in the drawbar. Put nuts on the 1/2 inch bolts and tighten them down evenly until the center pops loose. After that if you need to get at the clutch bearing, at the front of the reduction gear housing is the clutch fork shaft. You will recognize this as the shaft the clutch pulley brake mounts to. Remove the 4 bolts that hold the shaft housing to the reduction housing and remove the pin from the clutch rod yoke. Pull this assembly out forward. after that, you can simply pull the entire pulley off the tractor and you will see the bearings from the back of the pulley. Good luck and Call me at1-605-996-3575 if you have any questions.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|