Tractor Talk Discussion Board |
Re: Re: Re: marvel schebler carb
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe (Wa) on May 30, 2004 at 10:18:50 from (65.126.49.71):
In Reply to: Re: Re: marvel schebler carb posted by Ron on May 30, 2004 at 05:52:20:
Yes, I agree that the level in the bowl has some bearing on a loaded engine but what has been pretty much ignored in most of these posts is he cannot get a combustible mixture to start the engine. The only thing that is germane to starting and idling is shown in that picture plus the pressure differential provided by the cranking engine. The main function of the venturi is to atomize the fuel. When the throttle valve is closed that function is assumed by the bevel on the throttle plate. That is why it is important to have the correct plate and that it is not installed upside down. For starting and idling, as long as the bowl has fuel and atmospheric pressure, it doesn’t matter if the float level was set at 1/8” or 1/2”, It doesn’t matter if the fuel line is connected to the carb, it doesn’t matter if the power mixture valve is shut disabling the entire power fuel circuit. So why address everything from the gas tank vented cap to the main jet? It’s irrelevant to this post. Perhaps I am misreading the question in the initial post. If so I apologize in advance and will slink away. In fact the sun is shining here finally after a week of daily rain. I am going out and play with my tractors. Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|