Tractor Talk Discussion Board |
Re: Brush Hog - 5' or 6'
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on May 27, 2004 at 09:16:08 from (199.46.199.230):
In Reply to: Brush Hog - 5' or 6' posted by Steve MO on May 27, 2004 at 07:07:47:
6' will work fine. You have the hp and the weight to lift it. It will test your hydraulics more than the 5' however. If the ground is flat or gently rolling hills I'd go with the larger machine as the 6' cuts much faster than the 5. But if you have a lot of chop or terraces or anything that is irregular, the larger mowers tend to be bottoming out all the time and not only do they scalp, but it is hard on the whole drive train, including the tractor. Be sure and get a gear box rated at or above your tractor. Thinking aloud, your 800 series will just squeak by with a 45 hp which is the smallest they put on them as I recall. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|