Tractor Talk Discussion Board |
Re: Roosa-Master Surprise, Surprise
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george md on May 08, 2004 at 08:35:12 from (64.63.221.171):
In Reply to: Roosa-Master Surprise, Surprise posted by txblu on May 08, 2004 at 06:30:21:
txblu, Many of the systems from the 50's and 60's did not have a housing pressure regulator in the return line . If you have one in the return line, then his advice is correct , if you don't have one , then you had better find out what caused the line to be blocked . Usually blocked by the pieces of the governor drive ring that has become old and brittle and has shattered and floated out with the return fuel. If this is the case , some where in the near future you will cut off the rivots that are in the gov drive plate and at that point you no longer have any governor control. You don't have runaway engine, you have over speed engine and runaway operator. george
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|