|
Tractor Talk Discussion Board |
Re: Glow plug relay
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jdemaris on April 26, 2004 at 06:04:50 from (209.23.31.99):
In Reply to: Glow plug relay posted by kraigWY on April 25, 2004 at 16:09:12:
I don't remember what the original looks like. I replaced mine years ago with a Ford "fender mount" automotive starter relay; they cost about $7. I use the same relay on all my diesel trucks too. Cheap and reliable. Seems the original must have two big poles - one from the battery source and one to the glow-plug circuit (which is in series on the IH B-275). Then there should be either one, or two small terminals. One is to engergize the relay with low-draw 12 volt power. If there is another, it could be several things depending on the model of the relay. Some are NOT self-grounding, so the terminal must be grounded. Other's have the little terminal marked "R" for resistor, and is used for the ignition resistor bypass on gas engines. Just about any auto parts store or tractor parts store has the relays. YOu can buy them in part-time duty (like the Ford application), full-time duty, high amp draw,low amp draw, self-grounding, etc.
Remember that with the IH B-275 - if that is the tractor you're working on, has all the glow-plugs are wired in series with the glow-plug resistor/indicator on the dashboard. If any of the connections are bad, or if any of the glowplugs are bad, nothing will work. It will take Champion #155 glow-plugs (the plugs will have an AG number, but the box will be numbered #155).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
