Tractor Talk Discussion Board |
Re: fuel gauge 861 ford
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MacSC on April 03, 2004 at 07:35:58 from (69.19.30.69):
In Reply to: fuel gauge 861 ford posted by gary belote on April 02, 2004 at 19:38:30:
1)could be a hole in the float in gas tank and is therefore full of gas 2)wire from sender -the thing in the tank- to the gauge is not making good contact on one or both ends 3)the tank itself in not grounded properly to frame of tractor due to rust, paint, etc where it is bolted onto the frame. Had all the above problems and finally got it fixed then converted to 12v and forgot about the guage and fried it so I'm once again using the STICK!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|