Tractor Talk Discussion Board |
Re: Siclebar knife section RR (?)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Buzzman72 on March 15, 2004 at 06:59:50 from (67.241.50.214):
In Reply to: Siclebar knife section RR (?) posted by Indydirtfarmer on March 15, 2004 at 03:32:52:
When I was a kid back in the '60's working at the Farmall garage with Dad and Grand-Dad, I replaced a lot of sections in sickle bar mower knives. Usually, I'd use the hand-held grinder to grind off the rivet heads; then remove the remainder of the rivet with a punch. To install the new sections, Dad had a cast-iron block that was machined the correct distance between then rivets; I'd set up the rivets with the heads on the block, thru the section and the knife; then Dad had a special rectangular-shaft punch to put the correct "finish" on the rivets. Not for sure, but I kinda think IH sold the punch and the block as a kit at one time. When Grand-Dad did it, we always said he "cheated"; he had a rivet press that was set up in the bench vise; when the rivets, section and knife were positioned, one pull of the lever "finished" the rivets on one section. Not sure who made the press, but it sure was handy!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|