Tractor Talk Discussion Board |
Re: 2000 Ford F 350 4X4 reverse problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Vern-MI on March 09, 2004 at 07:38:42 from (207.69.137.9):
In Reply to: 2000 Ford F 350 4X4 reverse problem posted by Todd Smith on March 08, 2004 at 19:24:28:
Todd, I just thought of two other problems with that vintage E4OD transmission. The turbine hub inside the torque converter wanted to wear into the inside of the converter cover and cause all sorts of nasty things to happen. Diesel torsionals are very hard on the transmission especially to the converter during the lockup mode. The older open converters allowed the torsionals to be absorbed in the hydraulic converter coupling. Also the switch on the side of the transmission (drivers side) surrounding the manual lever tends to want to get contaminated with dirt and water and short out. This causes the gear selection signal being sent to the computer to be in error and consequently incorrect elements are applied causing the lockup you describe. The switch is the easiest to change and costs about $40. Good luck and hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|