Tractor Talk Discussion Board |
Re: 12V regulator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RusselAZ on March 04, 2004 at 22:28:22 from (67.136.109.96):
In Reply to: 12V regulator posted by Jim Scarlott on March 04, 2004 at 22:00:20:
I don't think an automotive type regulator will work for you on this. Automotive regulators control generator/alternator output by varying the current through the windings. This is what the F terminal does. depending on the system the F terminal will either give a frequency ground (or positive)to the windings. I don't know what kind of solar panel you have but I haven't seen one that you could control what the panel puts out, only control the output with voltage control. A battery is a voltage controller in a sense. Or voltage absorber. If the job of your controllers that are giving up is to not overcharge the batteries by clamping off what voltage can get to them, then I think you are stuck with getting what is designed for it. An interesting problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|