|
Tractor Talk Discussion Board |
Re: low mod 12v conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on February 25, 2004 at 05:31:33 from (165.170.128.66):
In Reply to: low mod 12v conversion posted by karl f on February 24, 2004 at 20:21:14:
Karl - What you describe can be done but it's got a couple drawbacks: 1 - The generator won't charge unless the engine RPM's are run up fairly high. Means if you spend a lot of time running slow or idling the battery won't charge. 2 - Heat! When you double the system voltage, the heat generated in generator field windings heat is quadrupled. Result is hot-running generator and shorter life. You CAN however keep a positive ground system with this approach - the generator doesn't care about ground polarity. (Most of the early 12 volt generator systems were positive ground anyway….) Now if your tractor is for work (not a show tractor), I recommend replacing the old generator with an alternator. A rebuilt alternator will cost about the same as a 12 volt generator regulator. And an alternator will be more reliable, and provides more charging current - especially at idle - than a generator & regulator system.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
