Tractor Talk Discussion Board |
Re: handling round bails
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Road Warrior on February 16, 2004 at 20:34:53 from (216.174.160.141):
In Reply to: handling round bails posted by ray on February 16, 2004 at 16:13:29:
I use my Farmall H with 3 point hitch to haul bales for my horses. The bales weigh around 1300 lbs., too much for the tractor without some extra weight on the front. I had some old brackets and 1 weight left over from a 4020 JD we owned. Lucky for me they bolted right on to the H. It's still kind of light on the front end, so I have to tap the brakes a little to keep her headed the right direction. hehe. BTW - I haul my bales almost a mile from the barn where they are stored. I've got about $900 in this tractor, counting the 3 point hitch.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|