|
Tractor Talk Discussion Board |
Remote hydraulics questions (kinda long)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bud on February 11, 2004 at 09:13:08 from (148.64.47.177):
I am building a fence post driver for my tractor. I am pretty green on hooking up the hydraulics. I have three cylinders. One to lift the driver weight, and two for lateral leveling (fore/aft and side/side) The tractor that I am using is a Case 1070 with two remotes. The levers inside the cab are spring loaded to return to a neutral position when not in use.
My questions are;
1. Can I bungee the cab lever to provide a source of hydraulic pressure to the driver which then has it's own control valves to operate the three cylinders?
2. I have seen commecial drivers work and the operator pulls a control valve lever which operates the lift cylinder mechanism and when the operator lets go of the control the cylinder "free falls" back to the retracted position. If I have the cab control bungeed open, will I still be able to do the same also?
3. I am confused as to the difference between double and single acting cylinders. I would assume I think that I need a single acting cylinder for the lift cylinder. What about the other two position cylinders?
4. I am also confused about what type of control valve to buy to allow me to operate the three cylinders off the tractor.
Yes I am totally green when it comes to hydraulics and if someone would be so kind as to perhaps draw me a schematic I would be well on my way to fence post driving nirvana! :) I will post pictures for the board when I am finished with the construction. Thanks in advance for any help and if someone needs to email me with details...nospamflyingvranch@earthlink.net
Thanks again folks!
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
